Brother 9840CDW - Color Laser - All-in-One Quick Setup Manual page 43

Installing the Driver & Software
2
Plug the AC power cord into an AC outlet. Turn
the power switch on.
Improper Setup
If you have previously configured the wireless
settings of the machine you must reset the
network (LAN) settings before you can
configure the wireless settings again.
Press Menu, 7, 2, 5 (or Menu, 7, 0) and then
press 1 to accept the change.
3
On your machine, press Menu, 7, 2, 2.
72.WLAN
WLAN Enable ?
a
On
b
Off
Select ab or OK
Press or to choose On, then press OK.
The wired network interface will become
inactive with this setting.
4
The machine will search for your network and
display a list of available SSIDs. You should
see the SSID you wrote down earlier. If the
machine finds more than one network use the
or keys to choose your network, then
press OK. Go to step 8.
72.WLAN
SSID
a
salesgroup
b
ABCgroup
Select ab or OK
Note
It will take several seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step 5.
5
Select <New SSID> using
OK. Go to step 6.
72.WLAN
SSID
<New SSID>
Select ab or OK
6
Enter a new SSID and press OK. For
information how to type text, see Entering
text on page 48.
72.WLAN
SSID:
Enter & OK Key
7
Press or to choose Infrastructure,
then press OK.
8
Use the , and OK keys to choose one of
the options below: If your network is configured
for Authentication and Encryption you must
match the settings used for your network.
No Authentication or Encryption: Choose
Open System, press OK then choose None
for Encryption Type and press OK. Then
press or to choose 1.Yes and press OK
to apply your settings. Go to step 12.
No Authentication with WEP Encryption:
Choose Open System, press OK then use the
or to choose WEP for the
Encryption Type and press OK. Go to
step 9.
Authentication with WEP Encryption:
Choose Shared Key, press OK. Go to step 9.
Authentication with WPA/WPA2-PSK (TKIP
or AES Encryption): Choose
WPA/WPA2-PSK, press OK. Go to step 10.
Authentication with LEAP: Choose LEAP,
press OK. Go to step 11.
Macintosh
or and press
41
®