Error And Maintenance Messages - Brother 9045CDN - DCP Color Laser User Manual

Error and maintenance messages

As with any sophisticated office product, error and maintenance messages may be displayed. The
most common error and maintenance messages are shown below.
Error Message
Access Error
Calibrate
Cartridge Error
Put the Black (K)
Toner Cartridge back
1
in.
1
The toner cartridge
colour with the
problem is shown in
the message.
Change Parts
Belt Unit
Change Parts
Drum
Change Parts
Fuser Unit
Change Parts
Laser Unit
Cause
The device is removed from the
USB direct interface while the
data is processing.
Calibration failed.
The toner cartridge is not installed
properly.
It is time to replace the belt unit.
The drum unit is near the end of
its life.
The drum unit counter was not
reset when a new drum was
installed.
It is time to replace the fuser unit. Call your Brother dealer to purchase the fuser
It is time to replace the laser unit. Call your Brother dealer to purchase the laser
Troubleshooting and routine maintenance
Action
Press Stop/Exit. Reinsert the device and try to
print with direct print or PictBridge.
Press Black Start or Color Start and try
again.
Do one of the following:
Turn off the machine's power switch. Wait
a few seconds, then turn it on again.
Put in a new drum unit. (See Replacing the
drum unit on page 123.)
Put in a new belt unit. (See Replacing the
belt unit on page 130.)
Put in a new waste toner box. (See
Replacing the waste toner box on
page 134.)
If the problem continues, call your Brother
dealer.
Pull out the drum unit, take out the toner
cartridge that is indicated on the LCD, and put
it back into the drum unit again.
Replace the belt unit. (See Replacing the belt
unit on page 129.)
Use the drum unit until you have a print quality
problem; then replace the drum unit with a new
one.
(See Replacing the drum unit on page 123.)
Press Menu, 6, 6, and then
Drum. Press OK and press 1 to reset the drum
unit counter.
unit.
unit.
C
C
or to choose
a b
81