Download Print this page

Additional Information; Troubleshooting; Specifications; Cleaning The Unit - Pioneer IDK-01 Operating Instructions Manual

Control dock for ipod
Hide thumbs

Advertisement

Table of Contents

Additional information

Chapter 5
Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Problem
No sound/no picture.
Operation doesn't seem possible
after connecting the SR cable from
this unit to an external component.

Specifications

Power section and miscellaneous
Power requirements (using the supplied adapter)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC 12 V
Dimensions . . . 99 mm (W) x 33 mm (H) x 74 mm (D)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 g
Accessories
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . 1
(CR2025)
Lithium battery
iPod type adapter
. . . . . . . . . . . . . . . . . . . . . . . . 6
AC adapter
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Plug adapters (for AC adapter) . . . . . . . . . . . . . 2
Audio cable (2 m) red/white . . . . . . . . . . . . . . . . 1
Video cable (2 m) yellow . . . . . . . . . . . . . . . . . . . 1
SR cable
(2 m). . . . . . . . . . . . . . . . . . . . . . . . . . 1
These operating instructions
Warranty card
. . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Remedy
• Make sure your iPod is working properly.
• Make sure the iPod is seated correctly in the iPod connector dock.
• Make sure you have properly connected the AV outputs from the dock
to your external components. Also check that the correct input is
selected on your receiver and/or monitor.
• If you have connected the S-video output, nothing is output from the
standard (composite) video output.
• For operation, you must point the remote control supplied with this
unit at the remote sensor of the connected receiver or amplifier.
• Make sure you are using the SR cable supplied with this system.
. . . . . . . . . . . . . . . . . . 1
. . . . . . . . . . . . . . 1
Note
• Specifications and design subject to
possible modification without notice, due
to improvements.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out
well, and then wipe again with a dry cloth. Do
not use furniture wax or cleansers.
• Never use thinners, benzine, insecticide
sprays or other chemicals on or near this
unit, since these will corrode the surface.
Published by Pioneer Corporation
Published by Pioneer Corporation
Copyright ©2006 Pioneer Corporation
Copyright ©2006 Pioneer Corporation
All rights reserved
All rights reserved
05
11
En

Advertisement

Table of Contents
loading

  Related Manuals for Pioneer IDK-01