Enabling Or Disabling A Device; Selecting A Startup Device; Selecting A Temporary Startup Device - Lenovo 7522D6U User Manual

Enabling or disabling a device

This section provides information on how to enable or disable user access to the
following devices:
SATA Controller
Floppy A
To set the SATA Controller, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → ATA Drives Setup →
3. Select the desired settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and
To set the Floppy A, do the following:
1. Start the Setup Utility program (see "Starting the Setup Utility program" on
2. From the Setup Utility program menu, select Devices → Floppy Drive Setup →
3. Select the desired settings and press Enter.
4. Return to the Setup Utility program menu and select Exit → Save Changes and

Selecting a startup device

If your computer does not start up from a device such as the CD-ROM, diskette, or
hard disk drive as expected, use one of the following procedures to select a startup
device.

Selecting a temporary startup device

Use this procedure to startup from any start device.
Note: Not all CDs, hard disk drives, and diskettes are bootable.
1. Turn off your computer.
2. Press and hold the F12 key, and then turn on the computer. When the Startup
When this feature is set to Disabled, all devices connected to the
SATA connectors (such as hard disk drives or the optical drive)
are disabled and will not be displayed in the system
configuration.
When this feature is set to Disabled, the diskette drive cannot be
accessed.
page 47).
SATA Controller.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
page 47).
Floppy A.
Exit.
Note: If you do not want to save the settings, select Discard Changes and Exit.
Device Menu appears, release the F12 key.
Note: If you are using a USB keyboard and the Startup Device Menu does not
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
Chapter 4. Using the Setup Utility
49