Using The Supplied Power Cord Stopper - NEC NP-PX700W User Manual

Using the Supplied Power Cord Stopper

To prevent the power cord from accidently removing from the AC IN of the projector, attach the supplied power cord
stopper to clamp the power cord.
NOTE:
• Do not clamp the power cord with other cables. Doing so can generate noise, which can affect adversely the signal cable.
CAUTION
• Do not bundle the power cord. Doing this could cause heat or a fire.
• Do not clamp two power cords that would be used when stacking two projectors. Doing this could cause a
fire.
NOTE: Be careful not to insert the band inversely. Once the band is attached, it cannot be removed from the slot.
Attaching the power cord stopper
1. Insert the end of band of the power cord stopper into the slot next to the AC IN on the terminal panel.
2. Use the power cord stopper to clamp the power cord.
Push the clamper to lock it.
Clamper
3. Slide the clamper to the hilt of the power cord.
2. Projecting an Image (Basic Operation)
14