Advertisement
1 Preparation before washing
Preparation before washing
1.Connect the water inlet hose.
2.Confirm that the washing machine is earthed
3.Put down the drain hose.
4.slanting or uneven ground may result in
Pay attention to followings before washing the laundries
Clear the pocket.
Confirm if there's
Fasten the buttons
special requirement
Take out the coins ,
and zippers.
sand, hairpins etc.
for the laundries.
a. Check if the laundries are applicable for washing with machine.
b. Divide the laundries with unfast color from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust. For the parts with heavy soil,
please apply detergent in advance, which can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn it over before putting in.
f. Do not put those laundries polluted by chemicals directly into the washing machine.
For those small laundries and those may get twisting or worn, and woolen/fur laundries, please put them into
mesh bag for washing.
reliably. Then insert the power plug into the
receptacle. Do not connect the earth terminal
to the gas pipe and tap water pipe.
unstable working or abnormal noise. Please
make the machine stand horizontally.
The quantity of the
When the pulsator is
laundries shall not
running ,the buttons of
exceed the rated
the laundries may cause
value. The big
noise. For the sake of
laundries like the
discretion ,please put
jeans shall be put
the laundries with
in loosely.
buttons into other
laundries.
2.Put in the laundries
The capacity of washing of the machine refer to the largest weight of the
standard laundries under dry condition that can be washed in one
time. Laundries quantity in one washing cycle shall be lower than
the rated capacity.
The thickness ,size , type of the cloth will influence the actual washing capacity.
It is suitable to put in reasonable amount of laundries and the laundries can be turned
round in washing for one time washing.
Do not select " 4" water level for laundries less than 1.0kg ,so as to avoid
splashing of water.
3. Usage of detergent
Control panel seat
Softener inlet
Liquid detergent
inlet
Washing powder inlet
Washing powder box
Add washing powder and softener into the
box directly as per indicated in left figure.
After adding, close the box.
How to use whitener
When choosing the " No washing powder" program, the
usage of softener or bleacher is same as using detergent.
Add water to stipulated level. Dilute the whitener with container,
and then pour it into the liquid whitener inlet slowly.
Laundries with color or pattern is not colorfast, thus not applicable.
The whitener shall not touch laundries directly.
See to the manual of whitener for the usage and dosage.
For whitener in powder, dissolve it before use.
4. Close the top lid
As the top lid opened, the washer will automatically given alarm and stop running, exclusively during draining.
How to use washing powder
It is suggested to add washing powder into the box
directly under fuzzy program and reserve program.
Dissolve directly inside the washing machine: (not
applicable for fuzzy and reserve program)
1.Add some water
2.Add washing powder. Run for about 30s to fully dissolve
the Powder. Then push the"START/PAUSE" button.
3.Put in laundries. Select suitable water level. Push the
"START/PAUSE" Button again.
Quick dissolving of washing powder:
1.Prepare warm water of 30 C and container.
2. Add washing powder while stirring to dissolve it completely.
Please add suitable washing powder as per the laundries
quantity, the set water level and water quantity.
If you select POSTH ASTE program, it is suggested to use
"
"
liquid detergent instead of washing powder to guarantee
the washing effect.
It is not recommended to use rich-foam washing powder.
Washing powder with poor quality or long-time storage may
get caked. Please clean the detergent box duly in usage.
Advertisement
