Usage Of The Drain Hose - Haier HWM55-0528 User Manual

How to change the direction of the drain hose
1.Dismantle the back cover of the washing
machine.
2.Put down the drain hose. Take off the
drain hose frame. As indicated in Figure
1, put the drain hose into the cabinet.
Then stretch one hand into the cabinet
to nip the claw of the drain hose bush-
ing to remove the claw from original
position. Take off the drain hose bush-
ing with the other hand. (As indicated in
Figure 2 and 3).
Outer
drain
hose
Drain hose frame
Figure 1
Cabinet
Inner
Press
Drain hose
bushing claw
Press

Usage of the drain hose

The drain hose shall drain smoothly
1.The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not trample or press the drain hose.
If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
Drain hose bushing
Figure 2
Outer
Drain hose
bushing
Take off
Figure 3
3.Dismantle the protecting cover of the
drain outlet at the other side (method
the same as the bushing). Install the
bushing as per indicated in Figure 4.
4.Extend the drain hose from the other
side. Fix the drain hose onto the base
frame with the drain hose frame. (As
indicated in Figure 5)
Drain outlet
protecting cover
Drain hose bushing
Figure 4
5.Install the protecting cover of the drain
outlet at the other side as per indicated
in Figure 6.
4.If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it
either at A or at B point.
Figure 5
Figure 6