Page of 16

HP 1200 - LaserJet B/W Laser Printer Getting Started Manual

Hp laserjet 1200 copier/scanner - copier/scanner getting started guide.
Hide thumbs
getting started guide
opsætningsvejledning
leitfaden zur inbetriebnahme
guía de instalación rápida
guide de mise en marche
guida introdutti'va
handleiding aan de slag
guia de primeiros passos
o
lea esto primer
o
hp LaserJet 1200
copy scan
copier numériser

Advertising

   Also See for HP 1200 - LaserJet B/W Laser Printer

   Related Manuals for HP 1200 - LaserJet B/W Laser Printer

   Summary of Contents for HP 1200 - LaserJet B/W Laser Printer

  • Page 1

    getting started guide opsætningsvejledning leitfaden zur inbetriebnahme guía de instalación rápida guide de mise en marche guida introdutti’va handleiding aan de slag guia de primeiros passos lea esto primer hp LaserJet 1200 copy scan • copier numériser •...

  • Page 2

    à la section 15 de la notice FCC or translation without prior written permission is relative aux interférences radioélectriques. Ces Hewlett-Packard makes no warranty of any kind prohibited, except as allowed under the limites sont conçues pour fournir une protection with respect to this information.

  • Page 3

    Preparation/Préparation i n v e n Review package contents. Make sure all parts Locate parts. 1) Copier/scanner media input Unplug the printer. Turn off the printer power are included. 1) Copier/scanner. tray. 2) Copier/scanner output bin. 3) Long switch (220 V models only) and unplug the 2) Copier/scanner media input tray.

  • Page 4

    Assembly/Montage...

  • Page 5

    Install the copier/scanner. Place the Attach the copier/scanner cable. Attach the Reattach the left side panel. 1) Insert the left copier/scanner unit on top of the printer. Firmly cable to the edge of the I/O board. Make sure side panel tabs behind the edge of the front slide the copier/scanner towards the rear until it that the connection is secure.

  • Page 6

    Close the toner door. The toner cartridge Install copier/scanner trays. 1) Insert the Attach the power cord. Connect the power engages when the door is closed. copier/scanner media output bin into the cord to the printer and an AC outlet. Turn on the copier/scanner.

  • Page 7

    Test the copier. Place a document in the Troubleshooting the copier. 1) Check the 3) If the copier/scanner was not recognized, copier/scanner input tray, and press the Copy configuration page to verify that the verify that the copier/scanner cable is firmly button.

  • Page 8

    XXXmax Install the software. Choose and install the 1) Select Install from the autorun screen. If 2) Follow the instructions on the screen. Click appropriate CD for your software installation. autorun does not occur, select Start, select Finish to complete the installation 3) After the Use CD #1 for Windows or CD #2 for Run, and type x:\setup (where x is the letter of installation is complete, connect the I/O cable to...

  • Page 9

    Installing on Macintosh (USB). 1) Connect 6) Click Next when the setup assistant starts. Test the scanner. Place a document in the the I/O cable to the computer. 2) Insert the 7) Under Select Device, choose USB, and copier/scanner input tray, and press the Scan CD-ROM.

  • Page 10

    Click Scan, then select your printer from the Congratulations! Your HP LaserJet 1220 Destination field. Click OK. The document product is ready to use. If you had any should feed into the copier/scanner. The copy problems, refer to the troubleshooting chapters should appear in the printer output bin.

  • Page 13

    XXXmax...

  • Page 15

    i n v e n...

  • Page 16

    2001 Hewlett-Packard Co. *C7046-90901* *C7046-90901* www.hp.com/support/lj1220 C7046-90901...

This manual also for:

Laserjet 1200, Laserjet 1200

Comments to this Manuals

Symbols: 0
Latest comments: