Time Client Configuration Options; Configure The Time Client; Static Routes; Add A Static Route - Efficient Networks SpeedStream 5100 Series User Manual

Time Client Configuration Options

•
Primary Server IP Address
Specifies the primary IP address of a "well-known" Network Time Protocol Server (NTPS).
•
Secondary Server IP Address
Specifies the secondary IP address of a "well-known" NTPS. If the router does not receive a response
from the primary NTPS, it will switch to the secondary.

Configure the Time Client

1. On the main menu, click Setup, and then
click Time Client.
The Time Client Configuration window
displays.
2. Enter the Primary Server IP Address
for the time server.
3. If applicable, enter the Secondary Server
IP Address for the time server.
4. To save the settings, click Apply.

Static Routes

►Setup | Static Routes
Your SpeedStream DSL router directs data traffic by "learning" source and destination information, then
building a routing table. In some cases, network mappings cannot be learned because of incompatible
addressing schemes; or learned paths other than the desired source and destination may be possible. In
these situations, Static Routes can be configured to map these pathways, eliminating the need for the
router to learn them.

Add a Static Route

1. On the main menu, click Setup, and
then click Static Routes.
The Static Routes window displays.
2. In the Destination box, enter the IP
address of the destination server.
3. In the Netmask box, enter the IP
netmask of the destination server.
4. In the Next Hop box, enter the IP address to which the data packets will be forwarded.
5. From the Interface list, select the interface that will forward the data packets.
:
:
59
SpeedStream Router User Guide