Tuning Your Television for the VCR
You must tune your television for the VCR only if you are not using
a Scart cable
To view pictures from your VCR when a Scart cable is
used, the television must be set to the audio/video mode
Switch on the television.
Switch on the VCR by pressing STANDBY/ON on the front of the
VCR or STANDBY/ON on the remote control.
Select a programme position on the television to be reserved for
use with your VCR.
Insert the video cassette in the VCR. Check that the VCR starts
reading the cassette; if not, press
Start a scan on your television or set the television to UHF
Fine tune the television until the pictures and sound are obtained
If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the VCR output channel (see Setting the VCR Output Channel
on page 16 and Problems and Solutions on page 41).
When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television.
That programme is now reserved for use with your VCR.