Samsung SV-232B Instruction Manual: Technical Specifications

Hide thumbs

Technical Specifications

B
Design and specifications are subject to change without notice.
MODEL
SV-633B/SV-630B/SV-6303B
Format
VHS PAL standard
Heads
Video: 4 rotary heads
Hi-Fi audio: 2 rotary heads
Audio/Control: 1 stationary head
Erase: 1 full track erase head
Receiving channel
UHF 21-69CH
Television system
STANDARD I-NICAM STEREO
Luminance
FM azimuth recording
Colour system
PAL: Down converted subcarrier
phase shifted direct recording
NTSC PB on PAL TV
Tape speed
SP 23.39 mm/sec
LP 11.69 mm/sec
Recording/playback time
SP 3 hours (E-180 Tape)
LP 6 hours (E-180 Tape)
REW time
About 60 sec in REW with E-180
VIDEO
Input
0.5 to 2.0 Vp-p; 75 ohm unbalanced 0.5 to 2.0 Vp-p; 75 ohm unbalanced
Output
1.0 ± 0.2 Vp-p; 75 ohm unbalanced
Signal-to-noise ratio
Better than 43 dB (SP)
Horizontal resolution
More than 240 lines
AUDIO
Input
-8 dBm, 47 Kohm unbalanced
Output
-8 ± 3 dBm, 1 Kohm unbalanced
Wow and flutter (WTD)
0.4% max (SP)
Signal-to-noise ratio
68 dB min (IHF A filter)
Frequency response
20Hz - 20kHz
Power requirement
230V (AC 50-60 Hz)
Power consumption
Approx. 17 watts
Operation temperature
41°F-104°F (5°C-40°C)
Operation humidity
10%-75%
Weight
3.3 Kg (net)
Dimensions (WxHxD)
360 x 94 x 285 mm
40
Problems and Solutions
Before contacting the Samsung after-sales service, perform the following simple checks.
No power
SV-233B/SV-231B/SV-230B
You cannot insert a video cassette
VHS PAL standard
Video: 2 rotary heads
The television programme was not recorded
Audio/Control: 1 stationary head
Erase: 1 full track erase head
UHF 21-69CH
Timer recording was unsuccessful
STANDARD I
FM azimuth recording
PAL: Down converted subcarrier
phase shifted direct recording
No playback picture or the picture
NTSC PB on PAL TV
is distorted
SP 23.39 mm/sec
LP 11.69 mm/sec
You cannot see normal broadcasts
SP 3 hours (E-180 Tape)
LP 6 hours (E-180 Tape)
About 100 sec in REW with E-180
Noise bars or streaks on playback
When the
during playback, the still picture
has severe "noise bars" streaks
1.0 ± 0.2 Vp-p; 75 ohm unbalanced
Better than 43 dB (SP)
Video Head Cleaning
More than 240 lines
-8 dBm, 47 Kohm unbalanced
-8 ± 3 dBm, 1 Kohm unbalanced
If when tuning in your TV to the VCR test
0.4% max (SP)
pattern your TV does not find the test pattern
42 dB min (IHF A filter)
or the pattern when found suffers from
interference, it may be due to the VCR output
channel clashing with the normal TV
transmissions in your area. To prevent this
230V (AC 50-60 Hz)
you will need to change the VCR output
Approx. 15 watts
channel in the following way
41°F-104°F (5°C-40°C)
10%-75%
3.3 Kg (net)
360 x 94 x 285 mm
If you are unable to solve the problem after reading the above instructions, note:
Then contact your nearest SAMSUNG after-sales service.
Problem
Check that the power plug is connected to a wall outlet.
Have you pressed the STANDBY/ON button?
A video cassette can only be inserted with the window
side up and the safety tab facing you.
Check the VCR aerial connections.
Is the VCR tuner properly set?
Check if the safety tab is intact on the cassette.
Was the STANDBY/ON button pressed to activate the timer?
Re-check the recording start/stop time settings.
If there was a power failure or interruption during timer
recording, the recording will have been cancelled.
Check to see if you are using a prerecorded tape.
Check the TUNER/EXTERNAL setting. It should be on
TUNER.
Check the TV/VCR aerial connections.
Press the TRK (
or
❿ II
button is pressed
A still picture may have "noise bars", depending on the
condition of the tape. Press the TRK (
SLOW motion to minimize this effect.
If poor pictures appear on a variety of cassettes, the video
heads may need cleaning. This is not a common problem
and unless it appears, the heads should not be cleaned.
When cleaning the video heads, read all instructions
provided with the head cleaning cassette. Incorrect head
cleaning can permanently damage the video heads.
1. Remove the aerial input plug from the socket marked (aerial
symbol) on the rear of the VCR.
2. Carry out the instructions "Tuning Your Television for the VCR"
(see page 14).
3. Carry out the instructions "Setting the VCR output Channel"
(see page 16), move the channel number several channels
down from the original setting. (example: from 60 to 57).
4. Replace the aerial plug into the socket marked (aerial symbol)
on the rear of the VCR.
5. Re-tune your TV to the VCR again by following instructions
"Tuning Your Television for the VCR" (page 14).
6. If the problem still exists repeat steps 1 to 5 moving several
more channels away from the original setting.
The model and serial number on the rear of your VCR
The warranty information
A clear description of the problem
GB
Explanation/Solution
) buttons to minimize this effect.
or
) buttons during
41

Advertising

   Related Manuals for Samsung SV-232B

This manual also for:

Sv-633b, Sv-630b, Sv-6303b, Sv-233b, Sv-231b, Sv-230b

Comments to this Manuals

Symbols: 0
Latest comments: