Table of Contents
Advertisement
Available languages
Available languages
OPERATING THE RECEIVER
User Mode
Select Driving Mode & Driving Size:
You have an option to choose the positioner's movement type:
Continuous, Step(Impulses) or Time(Seconds).
Position the antenna with north, south, east and west and use
the
/
/
/
keys to drive motor.
key drives to west,
key drives to east,
key drives to north and
south.
Store Current
If you finished driving of motor, select "
Position
." and press the OK key, to reset new driving motor.
N N o o t t e e
:
The level indicated in the "Signal Status" is only for reference.
The signal quality may be adequate even though the level indicated is not maximum.
Go to Stored Position.
When the stored position is reached then screen displays "Stop",
you can now continue with the further operations.
Select the Calculate Sat Positions to recalculate the satellite position and OK key.
Installer Mode
After checking the positioner's state, installer should use this menu.
He should set the "Disable Limits" before using User mode.
Select the Drive Motor West/East and use the
to drive motor.
key drives to west and
key drives to east.
Select "Enable Limits", in order to enable "Set Limit".
Select "Disable Limits", in order to disable "Set Limit".
Select "Reset Positioner" and OK key to reset positioner.
GB-22
key drives to
/
/
/
keys
P
E
R
S
O
N
A
L
V
I
D
E
O
1.3 Auto Scanning
The sub menu "Auto Scanning" will enable download of the channels automatically from the
preprogrammed satellites.
To download channels automatically:
You can select Off /All//Only Free option mode in each satellite.
Off : No Scan
All : Scan all the channels
Only Free : Scan free channels
Press the OK key. Auto Scanning menu will be displayed.
All the channels in the list from the selected satellite will be
automatically downloaded.
1.4 Manual Scanning
To tune-in new channels and weak signals, the DSB-9601C has been provided with the option
"Manual Scanning" where the channel data can be entered by the user. After selecting the
"Manual Scanning" from the Installation Menu, the following screen will be displayed:
Select the target satellite for manual search.
Load a transponder.
This option will enable the user to load any transponder from
the preprogrammed list available within the receiver.
N N o o t t e e
:
Especially on New tranpsonder at Load TR, this new
transponder can be added into transponder list so that
you can use it on Auto Scanning later, only if at least
one channel is found with this new transponder.
In order to save it, press the OK key.
Input the frequency of the transponder you want to find.
Input the symbol rate of the transponder you want to find.
Select the FEC(Forward Error Correction)of the transponder you want to find.
You can select the value of 1/2, 2/3, 3/4, 5/6, 7/8 or Auto.
Select the polarity of the transponder you want to find.
(Horizontal/Vertical/Circular Left/Circular Right)
In the case of horizontal, 18V and in the case of vertical, 13V are output through LNB line.
R
E
C
O
R
D
E
R
C
O
M
M
O
N
I
N
T
OPERATING THE RECEIVER
GB-23
E
R
F
A
C
E
Advertisement
Chapters
Table of Contents
