Using The Lithium Ion Battery Pack; Charging The Lithium Ion Battery Pack - Samsung VP-D303 Owner's Instruction Book

ENGLISH
Preparation

Using the Lithium Ion Battery Pack

The amount of continuous recording time available depends on.
- The type and capacity of the battery pack you are using.
- How often the Zoom function is used.
It is recommended that you have several batteries available.

Charging the Lithium Ion Battery Pack

1. Attach the battery pack to the camcorder.
2. Connect the AC Power adapter to an AC
cord and connect the AC cord to a wall
socket.
3. Connect the DC cable to the DC jack
socket on the camcorder.
4. Turn the Camera power switch to off, and
the charging indicator will start to flash,
showing that the battery is charging.
Blinking time
Once per second
Twice per second
Three times per second
Blinking stops and stays on
On for a second and
off for a second
5. When the battery is fully charged, disconnect the
battery pack and the AC Power adapter from the camcorder.
Even with the power switched off, the battery pack will
still discharge if it is left connected to the camcorder.
Notes
The battery pack may be charged a little at the time of purchase.
To prevent reduction in the life and capacity of the battery pack, always
remove it from the camcorder after it is fully charged.
24 24
Power Switch
Charging rate
Less than 50%
50% ~ 75%
75% ~ 90%
90 ~ 100%
Error - Reset the battery pack and
the DC cable
5
-
- Zoom
1.
2.
3.
4.
1 1
1 2
1 3
1 1
5.
.
50%
50% ~ 75%
75% ~ 90%
90% ~ 100%