Philips SBCRU252/00 Instructions For Use Manual page 5

Hide thumbs Also See for SBCRU252/00:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 47
Instructions for use
SHIFT KEY FOR EXTRA FUNCTIONS
Some equipment has more functions than are available here.
With the SHIFT button you can operate some extra functions of your equipment.
Hold SHIFT while pressing another button:
SHIFT - a + /a -:
SHIFT - P+ / P- :
Try the other SHIFT keys to discover other functions of your equipment.
BATTERIES
SETTING UP BY CODE ENTRY
Before you set up the SBC RU 252 to operate your equipment,
look up the first code for your equipment in the brands list.
1. Press TV or VCR/DVD to select the device.
2. Press and hold 1 and 3 at the same time for 3 seconds.
– The indicator LED lights up.
3. Enter the 4-digit code for your brand with the numerical keys.
– The indicator LED blinks twice to indicate successful set-up.
– Press buttons on the SBC RU 252 to check that the code works on your
equipment. If it does, write down this code inside the SBC RU 252's battery lid.
– If the equipment does not respond correctly, try the next code from the code list
until the equipment works properly.
– If none of the listed codes work, go to Chapter SETTING UP BY AUTOSEARCH
– Repeat steps 1 to 3 for every piece of equipment you want to operate.
SETTING UP BY AUTOSEARCH
Before you start, make sure the equipment is ready to receive infra-red signals.
The equipment must be switched on, there should be no obstacles between you
and the equipment, and you should be right in front of the equipment.
Before setting up a VCR, insert a tape and start Playback.
1. Press TV or VCR/DVD to select the device.
2. Press and hold 1 and 3 at the same time for 3 seconds.
– The indicator LED lights up.
3. Press Power y to start the search.
– Every time the LED lights, another code is tested.
When the right code for your device is found,
the equipment (TV) switches off, or the VCR/DVD stops playing.
Immediately proceed with step 4.
4. Press Power y twice to lock the code.
– The indicator LED blinks twice to indicate successful set-up.
– Turn on the equipment again and press the SBC RU 252's buttons to see
if they are working as expected. Some codes are quite similar.
If your equipment does not respond correctly, repeat steps 1 to 4 to find a
better code.
– Maximum search time is 8 minutes for TV and 4 minutes for VCR/DVD.
Change colour,
Change brightness.
Insert the batteries as indicated in the battery compartment
(rear of remote). Only use batteries of type R03, UM4 or AAA.
Replace the batteries when required, or at least once a year.
Notes
English
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ru252

Table of Contents