e Disconnect the wired connector that is connected to
connector CN4 on the process circuit board, and
connect it to connector P3 on the installed circuit
board. (Either cut or remove the band that binds the
wires.)
r Remove the wired connector that is connected to
connector CN3 on the process circuit board, and
connect it to connector P2 on the installed circuit
board.
Circuit board, an accessory to the cable
GND terminal
Process circuit board
CN3 (6-pin)
CN4 (8-pin)
t Connect the wire on the circuit board to the
receiver's GND terminal.
y Connect the control cable AW-CA12T11 to connector
P1 on the circuit board.
Connect the 12-pin connector to the PAN/TILT con-
nector on the lens I/F card.
-13-
Control cable AW-CA12T11