Making A Phone Call - Motorola SELECT 2000 Manual

Making a Phone Call

First make sure that the antenna is fully extended. Then switch
the phone on and enter your unlock code if necessary.
It will not be possible to make a phone call unless you are in an
area with PCS service. When a service has been found, a series of
rising bars, x, will show the signal strength.
You can make phone calls with any of the following methods:
Enter the number with the digit keys then press O.
•
• Use automatic redial.
• Redial the last number called.
• One-Touch Dial a Phone Book entry.
Recall a Phone Book entry using R or the Options Menu.
•
• Call an embedded number in a message.
Your phone's internal Phone Book can be used to store
A
names and telephone numbers. See the Phone Book Menu
for further details.
Digit Keys
You can dial the number with the digit keys just like your home
phone. Then just press O.
If you make a mistake, press and release C to remove the
A
last digit. Holding Cdown will remove the entire number.
The display will show
Calling
call. If the call is not answered, press O to end the attempt.
When the phone call is answered, the display will change to
for a few seconds, followed by
Connected
To end your call, press O.
18 Making and Receiving Phone Calls
while your phone attempts the
.
End Call?
Automatic Redial
If your call attempt does not succeed, the message
be displayed for five seconds. Press O to automatically redial
the phone number.
When the call is connected, you will hear a short ring tone.
The maximum number of redial attempts is set by your Service
Provider. If the phone call cannot be connected within this
maximum, the message
Redial Failed
Redialing the Last Number Called
i When in standby mode, press OO.
You can also retrieve then redial any of the last ten numbers called
or received by using Last Ten Calls
j
One-Touch Dialing
The quickest way to place a call is to use One-Touch Dialing.You
can One-Touch Dial any of the numbers stored in the first nine
locations of your Phone Book. Just press and hold the appropriate
digit key. For example, pressing and holding 2 will dial the
phone number stored in location 2 of your Phone Book. See
'Fixed Dialing' to determine which memory locations are setup to
be One-Touch Dialed.
You do not need to press O to call the number.
A
Redial? will
will be shown.
in Phone Book Menu.