Battery Disposal; Installing Your Battery; Removing Your Battery - Motorola SELECT 2000 Manual

Table of Contents

Advertisement

Using Your Phone While Charging
Your phone can be left on in standby mode while charging.
Remember that talking on the phone requires energy, so charging
will take longer if you make or receive calls.
If the phone is on or in a call while charging, you can
A
disconnect or remove it from the charger without losing
power or the active call.

Battery Disposal

To dispose of batteries, check with your local recycling center for
a battery recycler near you.
! Never dispose of batteries in the fire.
Equipment Care
Your Motorola PCS radiotelephone is designed for superior
durability under normal use conditions. Protect your PCS phone
from water damage that could result from spills or excessive
exposure to rain. Never submerge your PCS telephone.

Installing Your Battery

Place the battery onto the back of the phone just below the
marked arrow indicators. Then slide the battery upwards on the
phone's runners, until it locks into place.
! Do not slide the battery on from the bottom of the phone.
Doing so may cause damage to the phone's battery contacts.

Removing Your Battery

Press the release catch inwards and simultaneously slide the
battery downwards, until it stops. Then pull the battery away
from the rear of the phone.
! Switch off your phone before removing the battery. Failure to
do so may damage your phone memory.
About Your Phone, Battery, and SIM Card
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Select 2000e

Table of Contents