Table of Contents
Advertisement
1. Snap your pager into the docking station. For information on
connecting the docking station to your PC, see "The Infrared
Port" on page 17.
2. On your pager, select
3. Select
.
4. If this is the first time the FLEX PC Partner application is being
installed on your PC continue to the next section, "Configuring
FLEX PC Partner". Otherwise, see "Using the PC Partner
Shell" on page 57.
Configuring FLEX PC Partner
The FLEX PC Partner Configuration utility is run immediately
after installing FLEX PC Partner. It tells the FLEX PC Partner
application how your pager will be connecting to your PC. If you
change hardware (e.g., replace the charger with a new type of
charger) reconfigure the FLEX PC Partner application using the
following procedure.
1. From your desktop, double-click
-or-
From the Windows 95 taskbar, click
and click
2. From the PC Partner Shell, double-click
.
3. From the FLEX PC Partner Configuration dialog box, select the
appropriate serial port.
Ä
If the port selection is not correct, an error message appears
("No IR devices found").
4. In the Adapter list box, select the appropriate adapter.
5. Click
. If this is not the first time FLEX PC Partner has been
configured to your PC, click
the FLEX PC Partner Configuration partlet.
from the menu wheel.
.
, then point to
.
to save your choices and close
Using the PC Partner Shell
The FLEX PC Partner application consists of individual component
applications accessible from the FLEX PC Partner Shell, known as
partlets. Since each partlet operates independently, they can be
used in any order. Except as noted below, you must establish a
connection between your pager and your PC in order to open a
partlet.
The following partlets are currently available:
• Address Book (does not require connection to pager)
• Memory Usage
• Message Manager (does not require connection to pager)
• Backup Utility
• Restore Utility
• Application Manager
• Partner Configuration
From your desktop, double-click
-or-
From the Windows 95 taskbar, click
and click
1. Double-click the partlet's icon.
TIP Right-clicking an icon also displays a pop-up menu you can
use to open a partlet.
2. If the FLEX PC Partner Connect dialog box appears, click
.
.
, then point to
.
Advertisement
Table of Contents
