Specifications - Kenwood KRF-V6080D Instruction Manual

Specifications

AUDIO section
Rated power output during STEREO operation
DIN/IEC (63 Hz ~ 12.5 kHz, 0.7% T.H.D., at 6 Ω)
............................................................................... 100 W + 100 W
Effective power output during SURROUND operation
FRONT
(1 kHz, 0.7 % T.H.D. at 6 Ω one channel driven) ... 100 W + 100 W
(1 kHz, 10 % T.H.D. at 6 Ω one channel driven) .... 120 W + 120 W
CENTER
(1 kHz, 0.7 % T.H.D. at 6 Ω one channel driven) ................... 100 W
(1 kHz, 10 % T.H.D. at 6 Ω one channel driven) .................... 120 W
SURROUND
(1 kHz, 0.7 % T.H.D. at 6 Ω one channel driven) ... 100 W + 100 W
(1 kHz, 10 % T.H.D. at 6 Ω one channel driven) .... 120 W + 120 W
SURROUND BACK
(1 kHz, 0.7 % T.H.D. at 6 Ω one channel driven) ................... 100 W
(1 kHz, 10 % T.H.D. at 6 Ω one channel driven) .................... 120 W
Total harmonic distortion ......................... 0.05 % (1 kHz, 50 W, 6 Ω)
Frequency response (IHF'66)
CD/DVD ..................................... 20 Hz ~ 70 kHz, +0 dB ~ –3.0 dB
Maximum input level
PHONO (MM) ................................ 40 mV, 1.0 % T.H.D. at 1 kHz
Signal to noise ratio (IHF'66)
PHONO (MM) ........................................................................ 74 dB
CD/DVD, TAPE, VIDEO 1, VIDEO 2, DVD/6CH .................. 95 dB
Loudness control
VOLUME at –30 dB level ...................................... +8 dB (100 Hz)
Input sensitivity / impedance
PHONO (MM) ........................................................ 7.5 mV / 27 kΩ
CD/DVD, TAPE, VIDEO 1, VIDEO 2 ................... 550 mV / 47 kΩ
DVD/6CH INPUT .................................................. 550 mV / 15 kΩ
Output level / impedance
TAPE REC ............................................................... 550 mV / 1 kΩ
PRE OUT (SUBWOOFER) ...................................... 1.5 V / 2.2 kΩ
PRE OUT (SURROUND BACK) .............................. 1.5 V / 2.2 kΩ
Tone control
BASS ................................................................ ±10 dB (at 100 Hz)
TREBLE ............................................................ ±10 dB (at 10 kHz)
DIGITAL AUDIO section
Sampling frequency ...................... 32 kHz, 44.1 kHz, 48 kHz, 96 kHz
Input level / impedance / wave length
Optical ........................... (–15 dBm ~ –21 dBm), 660 nm ±30 nm
Coaxial ................................................................... 0.5 Vp-p / 75 Ω
Notes
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
40 EN
Caution : Read this page carefully to ensure safe
operation.
VIDEO section
VIDEO inputs / outputs
VIDEO (composite) ................................................. 1 Vp-p / 75 Ω
S-VIDEO inputs /outputs
S-VIDEO (luminance signal) .................................. 1 Vp-p / 75 Ω
S-VIDEO (chrominance signal) ....................... 0.286 Vp-p / 75 Ω
COMPONENT VIDEO inputs /outputs
COMPONENT VIDEO (luminance signal) ............. 1 Vp-p / 75 Ω
COMPONENT VIDEO (CB/CR-signal) ............. ±0.32 Vp-p / 75 Ω
FM tuner section
Tuning frequency range ................................. 87.5 MHz ~ 108.0 MHz
Usable sensitivity (DIN at 75 Ω)
MONO ..................... 1.3 µV / 13.2 dBf (40 kHz DEV., S/N 26 dB)
STEREO ................... 45 µV / 42.1 dBf (46 kHz DEV., S/N 46 dB)
Total harmonic distortion (DIN at 1 kHz)
MONO .......................................................... 0.2% (71.2 dBf input)
STEREO ....................................................... 0.8% (71.2 dBf input)
Signal to noise ratio (DIN weighted at 1 kHz)
MONO ................................. 65 dB (40 kHz DEV., 71.2 dBf input)
STEREO .............................. 60 dB (46 kHz DEV., 71.2 dBf input)
Stereo separation (DIN 1 kHz) ................................................... 36 dB
Selectivity (±300 kHz) ................................................................. 64 dB
Frequency response (30 Hz ~ 15 kHz) .................... +0.5 dB, –3.0 dB
AM tuner section
Tuning frequency range .................................... 531 kHz ~ 1,602 kHz
Usable sensitivity (30% mod, S/N 20 dB) ......... 16 µV / (600 µV/m)
Signal to noise ratio (30% mod, 400 Hz)
.................................................................. 50 dB (60 dBµV EMF input)
GENERAL
Power consumption ................................................................. 280 W
AC outlet
SWITCHED ........................................................ (total 90 W max.)
Dimensions .................................................... W: 440 mm (17-5/16")
Weight (Net) .............................................................. 7.8 kg (17.2 lb)
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below. Refer
to the model and serial numbers whenever you call upon your dealer for
information or service on this product.
Model_____________________ Serial Number_____________________
H : 143 mm (5-5/8")
D : 303 mm (11-15/16")