Kenwood K-501USB Instruction Manual page 35

Compact hi-fi component system
Hide thumbs Also See for K-501USB:
Table of Contents

Advertisement

3
Enter record-pause mode.
4
Start recording.
5
Start playing the auxiliary
component.
* This operation is not necessar y when
recording radio broadcasting.
If the memory card contains a folder named AL_Z90 or
higher, a message [CHECK REFRESH] is displayed and
Hint
recording cannot be started. In this case, it is required
to rearrange the folders by means of refreshing.
(See page 52.)
When recording completes:
The memory card stops and a message
[DATA WRITING] is displayed.
* Do not switch the system OFF or apply shock or
vibration to it while [DATA WRITING] is displayed.
* If the power to the system is shut off before [DATA
WRITING] disappears, the recorded data will be lost.
The memory card is put
to record-pause mode.
* A m e s s a g e [ D o n ' t
remove MEMORY CARD]
is scrolled.
Press the REC key again
to enter record mode.
* A m e s s a g e [ D o n ' t
remove MEMORY CARD]
is scrolled.
Dividing music during recording
During recording from the TUNER,
AUX or D.AUDIO source to a memory
card, the recorded music file can be
divided into multiple music files by
manually entering a track mark (music
division mark). Each press of the key
or knob creates a new music file from
that point.
If the audio recorded is distorted
or too low
Adjust the recording level. (See page 58.)
When the memory card becomes
full before completion of recording:
A message [STOP REC No Capacity]
is displayed. Erase the unnecessary
music files before retrying recording
from the beginning. (See page 36.)
Press at the point you
want to divide the music.
* The track marks can
also be entered
automatically. (See
page 59.)
35

Advertisement

Table of Contents
loading

Table of Contents