Table of Contents
Advertisement
Using the CD/MP3-CD/WMA-CD
Loading a disc
1 Press CD button to select CD mode.
2 Press the area marked push open to open the CD door.
3 Place a disc into the tray with the label facing up.
4 Close the CD door.
The total playtime and total number of tracks
will appear in the display.
5 To remove the disc, press the area marked
push open, grasp the disc by its edges, and
carefully pull it out.
For MP3-CD and WMA-CD only
Load a MP3 or WMA format music disc on the disc tray.
• The total album number and total file number
will appear on the display.
Notes:
•
To ensure good system performance; wait until the
unit completely reads the disc before proceeding.
•
If the CD compartment is not loaded with a disc or
the disc is unreadable, the message "NO PLAY"
will be blinking.
•
For MP3-CD and WMA-CD, the disc reading time
may exceed 10 seconds due to the large number of
songs compiled into one disc.
•
For MP3-CD and WMA-CD, "A" on the display rep-
resents ALBUM.
•
For MP3-CD and WMA-CD, the total album num-
ber on the display indicates the number of all the
albums recorded in the disc.
•
The icon "MP3" appears only when an MP3-file is
played. It does not appear when playing a WMA-file.
Playing a normal disc
1 Press 6 button (6 PLAY/PAUSE button on
the remote control) to start playback.
The track number and elapsed playing time of the
current track appear on the display.
To interrupt playback, press 6 button (6
PLAY/PAUSE button on the remote control).
The playing time will start flashing.
To resume playback, press 6 button (6 PLAY/
PAUSE button on the remote control) again.
2 To stop playback, press 7 button (STOP 7 but-
ton on the remote control) .
Selecting a desired track/passage
To select a desired track
Press 4 or ¢ button (4 or ¢ SEARCH/
SKIP/TUNING button on the remote control) re-
peatedly until the desired track appears on the
display.
• If playback is stopped, press 6 button (6
PLAY/PAUSE button on the remote control)
to start playback.
• The digit buttons (0~9) on the remote control
can also be used to select a track.
Press the digit buttons as shown below:
To select track 2 : 2 and ENTER
To select track 23 : 2, 3 and ENTER
To select track 120
(MP3-CD and WMA-CD only) : 1, 2 and 0
To search for a particular passage during
playback
Press and hold 4 or ¢ button (4 or ¢
SEARCH/SKIP/TUNING button on the remote
control) and released it when the desired passage
is located for CD.
Selecting a desired album/file
MP3-CD and WMA-CD only)
To select a desired album
Press p.call/album + or – button on the unit until
the desired album number appears on the display.
• "Axxx xxx" will appear on the display. "Axxx"
indicates album number and "xxx" indicates
the file number.
To select a desired file
Press 4 or ¢ button (4 or ¢ SEARCH/
SKIP/TUNING button on the remote control) re-
peatedly until the desired file from the current al-
bum appears on the display.
• "Axxx xxx" will appear on the display. "Axxx"
indicates album number and "xxx" indicates
the file number.
• The digit buttons (0~9) on the remote control
can also be used to select a file.
(For
9
EN
Advertisement
Table of Contents
