Using The Remote Control - Kenwood C-707I Instruction Manual

Using the remote control

After plugging the main unit into an AC wall outlet,
press the power [K] key on the remote control unit
to turn the system on.
After the system powers up, press the key for the
function you want to use.
Point the remote control at the remote sensor when
using it.
The remote control may not operate correctly
if direct sunlight or light from a high-frequency
fl uorescent lamp (such as an inverter type) is
shining on the remote sensor. If this happens,
move the system to a diff erent location to avoid
this type of malfunction.
Loading the remote control batteries
The batteries supplied with the system are for operational testing and may last only for a short time.
1 Remove the
battery cover.
CAUTION
2 Load the R6-size
batteries supplied with
the system.
Always replace the batteries with two new ones.
Check the polarity of the batteries (UV) when loading them.
Never heat or take apart the batteries, or put them in the fi re or the water.
If batteries are not used correctly, they may burst or leak. This will cause a fi re, injury
to persons or damage to the surroundings.
Component Names and Functions
15° 15°
3 Close the
battery cover.
Approx. 6 m
21
English