Sfp Operation; Approved Sfp Transceivers; Inserting An Sfp Transceiver - 3Com 4200G PWR Getting Started Manual

26 C 2: I
HAPTER NSTALLING THE

SFP Operation

Approved SFP
Transceivers
Inserting an SFP
Transceiver
S
WITCH
If there is evidence of a problem, see "Solving Problems Indicated by
LEDs" on page 54 for a list of suggested solutions.
CAUTION: The Switch has no ON/OFF switch; the only method of
connecting or disconnecting mains power is by connecting or
disconnecting the power cord.
The following section describes how to insert an SFP transceiver into an
SFP port.
SFP transceivers are hot-insertable and hot-swappable. You can remove
them from and insert them into any SFP port without having to power
down the Switch.
The following list of approved Gigabit Ethernet SFP transceivers is correct
at the time of publication.
3CSFP92 SFP (1000BASE-LX)
■
3CSFP97 SFP (1000BASE-LH70)
■
3CSFP93 SFP (1000BASE-T)
■
To access the latest list of approved SFP transceivers for the Switch on the
3Com Corporation World Wide Web site, enter this URL into your
internet browser:
http://www.3com.com
To be recognized as valid, the SFP transceiver must have the following
characteristics:
1000BASE-LX SFP transceiver
■
Use this transceiver to connect Gigabit Ethernet SFP ports on the
Switch directly to a single-mode fiber-optic cable or to multimode
fiber using a conditioned launch cable.
1000BASE-LH70 SFP transceiver
■
Use this transceiver to connect Gigabit Ethernet SFP ports on the
Switch directly to a single-mode fiber-optic cable.