Backing Up The Cx260 Last Image Configuration - Xerox DocuColor 252 User Manual

216

Backing Up the CX260 Last Image Configuration

The Spire CX260 includes two backup configurations:
•
Last Image (system backup)—only partition C is backed up
•
Factory Default—partitions C and D are backed up (this is performed in the
factory)
Attention: To ensure a successful backup, there must be at least 1 GB of disk
space available on partition C.
After installing a new version of the Spire CX260 software, you must perform a back
up. It is important that you have a backup of the current software version.
To back up the Last Image configuration:
1. Do one of the following depending on your configuration type:
•
For the Basic configuration, turn on your Windows-based computer,
Macintosh computer, or portable workstation and then connect to the Spire
CX260 via the Remote Desktop Connection.
•
For the Control Station and Pro Control Station configurations, turn on the
Spire CX260.
2. After the Spire CX260 software opens, exit the software and wait for the Spire
icon to disappear from the desktop taskbar.
Taskbar with Spire icon Taskbar with Spire icon
3. On the desktop, select Start > CX260 > CX260 Tools > System Backup and
Restore > Start system backup.
The system checks whether there is adequate disk space on partition C to
perform the backup. At least 1 GB is required.
Note: This process may take several minutes to complete. On the Spire
CX260, LED 5 illuminates steady green.
a. If there is adequate disk space, the following message appears.
Chapter 9 – Reinstalling the Spire CX260
Taskbar without Spire icon