Set Up A Gateway-To-Gateway Vpn Configuration - NETGEAR DGND3700 User Manual

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
Note: While your PC is connected to a remote LAN through a VPN, you
might not have normal Internet access. If this is the case, you have
to close the VPN connection to have normal Internet access.

Set Up a Gateway-to-Gateway VPN Configuration

Note: This section describes how to use the VPN Wizard to set up the
VPN tunnel using the VPNC default parameters listed in
page 89. If you have special requirements not covered by these
VPNC-recommended parameters, see
Special Circumstances
up the VPN tunnel.
Follow this procedure to configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
IP: 192.168.0.1
14.15.16.17
Gateway A
Figure 45. Gateway-to-gateway VPN tunnel
Set the LAN IPs on each wireless modem router to different subnets and configure each
correctly for the Internet. The subsequent examples assume the settings shown in the
following table.
Table 18. Gateway-to-gateway VPN tunnel configuration worksheet
Parameter
Connection Name
Pre-Shared Key
Secure Association
Perfect Forward Secrecy
Encryption Protocol
Set Up VPN Tunnels in
on page 111 for information about how to set
VPN tunnel
Internet
Value to Be Entered Field Selection
GtoGr
12345678
N/A
N/A
N/A
Virtual Private Networking
101
Table 16 on
IP:192.168.3.1
22.23.24.25
Gateway B
N/A
N/A
Main Mode Manual Keys
Enabled Disabled
DES 3DES