Download  Print this page

Sony SU-WL700 Additional Information For Using Page 6

Wall-mount bracket, compatible tv models for this wall-mount bracket information: xbr-52lx905/xbr-52lx900/xbr-46lx900/xbr-40lx900/kdl-55nx817/kdl-55nx811/kdl-55nx810/kdl-46nx810/kdl-52nx807/kdl-46nx807/kdl-52nx800/kdl-46nx800/kdl-46nx717/kdl-40nx717/kdl-4.
Hide thumbs
   

Advertisement

9
Secure the Mounting Bracket to the rear of the TV.
When using an electric screwdriver, set the torque setting to approximately  N•m {0 kgf•cm}.
 Tighten the bottom of the Mounting Bracket using two screws (+PSW M6 × 6).
 Be sure that all screws are securely tightened with equal torque to the rear of the TV.
10
Adjust the angle of the Mounting Bracket.
Use the supplied hexagon wrench.
When installing the Display parallel to the wall (0 degrees), adjustment of the Mounting Bracket angle
(procedures  and  below) is not necessary.
 Remove the two angle adjusting screws from the Mounting Bracket.
 Secure the screws to the corresponding holes for the desired angle (", " "5, " "0, " "5" or
"0").
Hexagon
wrench
• Be sure that both the left and right sides are set to the same angle, and secure the screws to the
corresponding angle holes (two screws for each side, left and right).
• Make sure that the two arms of the Mounting Bracket are screwed in securely.
CAUTION
Be careful not to pinch your fingers when adjusting the angle of the Mounting Bracket.
Additional Information for Using Sony Wall-Mount Bracket (SU-WL700)
Screw
− 6 −

Advertisement

Table of Contents

   Related Manuals for Sony SU-WL700

Comments to this Manuals

Symbols: 0
Latest comments: