Displaying Configuration Status - HP Integrity rx4610 User Manual

13 Displaying Configuration Status

The Configuration dialog box displays the managed server's configuration status. You can view this status
information whenever the DPC Console is successfully connected to a managed server through the
Emergency Management Port (EMP) or through a LAN-based form of the EMP (TCO mode).
To display the configuration status, select the Action  Configuration Status menu item. Doing so
causes the Configuration information box to appear. This box displays information in several areas:
Supported Viewers: Status on the FRU, SEL, SDR, and RSA viewers.
Security: Displays the Authentication Level, Activation Mode and Chassis Intrusion setting.
Authentication level: Indicates User or Administrator level. User level exists if you have a serial
connection through the EMP and EMP mode is set to restricted. User level also exists for LAN (TCO)
connections where a secure session is not available (e.g. someone else is already connected), or if there
is a restricted LAN access mode. Administrator level exists if you are logged in with administrative
rights.
Activation Mode: Indicates whether the server is always active or just active during pre-boot.
Chassis Intrusion: Indicates whether intrusion protection is set or not set.
Firmware: Displays the Intelligent Platform Management Interface (IMPI) and Baseboard Management
Controller (BMC) revisions on the server.
Aside from these designated areas, the Configuration dialog box also indicates the server's power state, the
operating system (if detected), and the presence of a service partition.
NOTE
In order for DPC Console to detect a connected server's operating system, the server must
have Platform Instrumentation (PI) installed.
27