Download  Print this page

Bin Setup Menu; Output Bin - Dell 5230 User Manual

Laser printers.
Hide thumbs

Advertisement

Menu item
Portrait Width
3–14 inches
76–360 mm
Portrait Height
3–14 inches
76–360 mm
Feed Direction
Short Edge
Long Edge

Bin Setup menu

Menu Item

Output Bin

Standard Bin
Bin <x>
Configure Bins
Mailbox
Link
Mail Overflow
Link Optional
Type Assignment
Description
Sets the portrait width
Notes:
If the width exceeds the maximum, the printer uses the maximum
width allowed.
8.5 inches is the US factory default setting. Inches can be increased
in 0.01-inch increments.
216 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
Sets the portrait height
Notes:
If the height exceeds the maximum, the printer uses the maximum
height allowed.
14 inches is the US factory default setting. Inches can be increased in
0.01-inch increments.
356 mm is the international factory default setting. Millimeters can
be increased in 1-mm increments.
Specifies the feed direction if the paper can be loaded in either direction
Notes:
Short Edge is the factory default setting.
Long Edge appears only if the longest edge is shorter than the
maximum width supported in the tray.
Description
Specifies the default output bin
Note: Standard Bin is the factory default setting.
Specifies configuration options for output bins
Notes:
Understanding printer menus
96
Mailbox is the factory default setting.
Bins assigned the same name are automatically linked
unless Link Optional is selected.
The Mailbox setting treats each bin as a separate
mailbox.
The Link setting links together all available output
bins.
The Link Optional setting links together all available
output bins except the standard bin and only appears
when at least two optional bins are installed.
The Type Assignment setting assigns each paper type
to an output bin or linked bin set.

Advertisement

Table of Contents

   Also See for Dell 5230

   Related Manuals for Dell 5230

This manual is also suitable for:

53505230dn5350dn5230n

Comments to this Manuals

Symbols: 0
Latest comments: