Viewing Reports; Adjusting Power Saver - Dell 5230 User Manual

Laser printers
Hide thumbs Also See for 5230:
Table of Contents

Advertisement

Viewing reports

You can view some reports from the Embedded Web Server. These reports are useful for assessing the status of the
printer, the network, and supplies.
To view reports from a network printer:
1
Type the printer IP address into the address field of your Web browser.
Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address
in the TCP/IP section.
2
Click Reports, and then click the type of report you want to view.

Adjusting Power Saver

Available settings range from 1–240 minutes. The factory default setting is 30 minutes.
To increase or decrease the number of minutes before the printer enters Power Saver mode, do one of the following:
Using the Embedded Web Server
1
Type the printer IP address into the address field of your Web browser.
Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address
in the TCP/IP section.
2
Click Settings, and then click General Settings.
3
Click Timeouts.
4
In the Power Saver box, increase or decrease the number of minutes you want the printer to wait before it enters
Power Saver mode.
5
Click Submit.
Using the printer control panel
1
Make sure the printer is on and Ready appears.
2
Press
.
3
Press the up or down arrow button until
4
Press the up or down arrow button until
5
Press the up or down arrow button until
6
Press the up or down arrow button until
7
Press the up or down arrow button to increase or decrease the number of minutes before the printer enters Power
Saver mode, and then press
Settings appears, and then press
General Settings appears, and then press
Timeouts appears, and then press
Power Saver appears, and then press
.
Administrative support
138
.
.
.
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

53505230dn5350dn5230n

Table of Contents