Sets the default printer language
PCL emulation uses a PCL interpreter for processing print
jobs. PostScript emulation uses a PS interpreter for processing
PCL is the factory default printer language.
Setting a printer language as the default does not prevent a
software program from sending print jobs that use another
Sets the logical and physical printable area
This menu does not appear if Edge to Edge is enabled in the
printer Setup menu.
Normal is the factory default setting. When attempting to
print data in the non-printable area defined by the Normal
setting, the printer clips the image at the boundary.
The Whole Page setting allows the image to be moved into
the non-printable area defined by the Normal setting, but the
printer will clip the image at the Normal setting boundary.
The Whole Page setting only affects pages printed using a
PCL 5e interpreter. This setting has no effect on pages printed
using the PCL XL or PostScript interpreter.
Sets the storage location for downloads
RAM is the factory default setting.
Storing downloads in flash memory places them in
permanent storage. Downloads remain in flash memory even
when the printer is turned off.
Storing downloads in RAM is temporary.
This menu appears only if a flash option is installed.
Specifies how the printer handles temporary downloads, such as
fonts and macros stored in RAM, when the printer receives a job
that requires more memory than is available
Off is the factory default setting. Off sets the printer to retain
the downloads only until memory is needed. Downloads are
deleted in order to process print jobs.
The On setting retains the downloads during language
changes and printer resets. If the printer runs out of memory,
38 Memory Full appears, and downloads are not deleted.
Understanding printer menus