SET-UP
Chute
Clean-Out
Tool
A chute clean-out tool is fastenedto the top of the augerhousing
with a mountingclip. See Figure6. The tool is designedto cleara
chuteassemblyof ice and snow.This item is fastenedwith a cabletie
at the factory.Cut thecable tie beforeoperatingthe snowthrower.
loft _1
.allmovingpartshave
stoppedbeforeusingthe clean-outtool to clearthe chuteassembly.
Tire Pressure
Beforeoperating,checktire pressureand reducepressurein bothtires
to between15 psiand 20 psi.
NOTE:If thetire pressureis notequal in bothtires,the unit maynot
travelin a straightpathand the shaveplatemay wearunevenly.
ADJUSTMENTS
Skid Shoes
The snowthrowerskid shoesare adjustedupwardat thefactory for
shippingpurposes.Adjustthemdownward,if desired,priorto operat-
ing the snowthrower.
It is not recommended that youoperatethis snowthroweron gravel
as it can easilypick up and throwloosegravel,causingpersonal
njuryor damageto the snowthrowerand surroundng property.
•
Forclose snow removalon a smoothsurface,raiseskid shoes
higheron the auger housing.
•
Use a middleor lowerpositionwhenthearea to be clearedis
uneven,such as a graveldriveway
NOTE:If youchooseto operatethe snowthroweron a gravelsurface,
keepthe skid shoesin positionfor maximumclearancebetweenthe
groundand the shaveplate.
f
ChuteClean-outTool
Figure6
/
Toadjustthe skid shoes:
1.
Loosenthe four hexnuts (two on each side)and carriagebolts.
Moveskid shoesto desiredposition. See Figure7.
2.
Makecertainthe entirebottomsurfaceof skid shoeis againstthe
groundto avoidunevenwearon the skid shoes.
3.
Retightennuts and boltssecurely.
Figure7
10