Before You Start; Prepare For Installation - Whirlpool AKP 803/01/IX Users Manual & Installation Handbook

Before you start

Please read the instructions carefully -
planning your installation will save you
time and effort.
look at the different ways the appliance
can be installed - as shown on the
following pages - and plan the installation
to suit your situation.
leave the appliance in the base tray
packaging until you are ready to install
it. When you remove the appliance from
the base tray packaging, take care not to
damage it.
Whilst every care is taken to eliminate
burrs and raw edges from this product,
please take care when handling - we
recommend the use of protective gloves
during installation.
Please note that the weight of this
appliance is approximately 47kg
(unpacked). Take care when lifting it into
the housing unit - always use an appropri-
ate method of lifting.
This appliance must be installed only at
low level - ie; under a worktop. The
controls have been designed for viewing
at a low level, and it should therefore not
be installed at high level.
Quantity colour
6 Silver
12 Black
6 Black
2 Silver
InstallatIon - 70cM
Description
No 8 x 12mm long
Self tapping screw
No 8 x 12mm long
chipboard screw
No 8 x 25mm long
chipboard screw
No 8 x 12mm long
Self tapping screw
Please note that all dimensions and sizes
given are nominal, some variation is to be
expected.
If this appliance is to be installed near to
a corner where the adjacent cabinets run
at right angles forward of the appliance,
there must be a gap of at least 90mm
between the appliance and the cabinets,
to prevent overheating of the cabinets.
Important: Do not modify the outer
panels of this appliance in any way.
Fixing screws - The fixing screws are in a
polythene bag in the oven pack. depend-
ing on the method of installation, some of
the screws may not be needed.
Step 1: Prepare for installation
There are 3 methods of installing the ap-
pliance:
• Method 1: Into a space between two
base units, ie; without a housing unit.
• Method 2: Into a housing unit,
with an internal height of less than
710mm, which can be modified to ob-
tain the required dimensions.
• Method 3: Into a housing unit, with
an internal height of 710mm or more.
If you have a non standard size of
cabinet which leaves a gap above or
below the appliance, you may be able
to buy a trim kit (to fill in the gap)
from the supplier of your cabinets.
for fixing
runners to appliance
runners and sidetrims to
cabinet or housing
Appliance to cabinet
Appliance to sidetrims