Water Connection - Whirlpool ADP 451 IX Instruction Manual

WARNING!

Water Connection

WARNING!
Insert the drain hose into a drain pipe with a minimum diameter o f 4 cm, o r let it run into the sink, making sure to
avoid bendin g or crimping. Use the special plas tic support that comes with the appliance. The free end of the hose
must be at a height between 40 and 100 cm and must not be immersed in water.
Water Outlet
Connect the water drain hose. The drain hose mu st be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
for personal safety:
Check with a qualified electrician or service representative if you are in doubt whether the
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
appliance is properly earthed.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
CONNECTION FROM THE POWER CORD.
please have a qualified electrician to install a proper outlet.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
Th e water supply to the applianc e can also be connected to the house hold hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case, the wash cycle time will be shortene d by about 15
minute s and the wash efficiency slightly reduced .
Th e co nnection must be made to the hot water line following the same procedures as
described in the sec tion for the c onnection to the cold water line.
In or der to avoid that there is more water staying in the inlet hose, please close
the hydrant after using.(Not applicable to appliances without aqua-stop.)
17
EARTHING