Table of Contents
Advertisement
<Ack Flag> <Address> <Group> <Command> <Data1> <Data2>...<DataN> <Stop>
where:
<Ack>
<Nack>
<Ack Flag>
<Address>
<Group>
<Command> = Two ASCII characters (ranging from [30h] to [39h], i.e. digits <0> to
<Data1>...
<Stop>
3.3 Available Commands
Note:
1. Write commands may become a request for the current value when only
= <?> (i.e. [3Fh]) is sent.
2. A character <X> means a "don't care" value in this section.
3. There is an availability table attached to each command. See the following table.
(1) Each gray shaded cell in the table means the source is not available for the
corresponding model.
(2) A dot, '
model. For instance, the command is available in EXT input, PAL model.
Source
PC ANALOG
PC DIGITAL
(DVI)
HDCP
[ NAME ]
2838 100 05424
= The ASCII character [06h], to tell the transmitter that the command has
been acknowledged.
= The ASCII characters [15h], to tell the transmitter that the command
has not been acknowledged, because the command itself is not valid
for any reason.
= <Esc> <%>, i.e. ASCII characters [1Bh] and [25h].
= 3 ASCII characters each of which ranging from [30h] to [39h], which are
used as monitor address.
= An ASCII character which identifies the command type, i.e. the same
identifier
of
the
acknowledged.
<9>, and from [41h] to [5Ah]), i.e.
command, i.e. the same identifier of the general command sequence
that is being acknowledged.
= Two ASCII characters (ranging from [30h] to [39h], i.e. digits <0> to
<9>, and from [41h] to [46h]), i.e. letters <A> to <F>), representing the
hex value of the data, or one ASCII characters when data are text
strings.
= <;>, i.e. the ASCII character [3Bh].
•
', means the command is available for the corresponding source and
Model
PAL
NTSC
Philips
general
command
sequence
letters <A> to <Z>), defining the
AP
CHINA
23
140
that
is
being
<Data1>
10
Advertisement
Table of Contents
Troubleshooting
