Philips BDL3221V/27 User Manual page 49

Troubleshooting
No sound
Video Problems
No Video
Low Quality DVD
playback
No sound
Remote Control Problems
Remote control does
not work properly
Product Specific Problems
file:///D|/My%20Documents/dfu/BDL_27/english/320wn6/SAFETY/saf_troub.htm (4 of 6)2006-03-10 1:30:38 PM
No sound output
when a program
with sound was
playing
No signal indicator
is displayed.
Picture not crisp
and some color
distortion
See video but no
audio
No response from
the LCD Monitor
when remote is
pressed
Ensure that the audio cables are firmly
connected to both the audio input connectors
on your the LCD Monitor and audio output
connectors on your PC or Video player.
Check Video Input Selection
Composite: Yellow colored RCA jack
S-Video: Typically a round 4 pin jack
Component: Typically 3 RCA jacks of
Green, Red and Blue.
Make sure you did not plug the video cable to
video output port behind the LCD Monitor.
Check DVD connection
Composite gives good picture
S-Video gives better picture
Component gives best picture
Check if the LCD Monitor volume is turn off of
muted.
Connect the audio cable securely.
Audio cable is connected incorrectly.
Verify that the audio source is selected
correctly in the OSD.
Point the remote control directly at the remote
sensor on the LCD Monitor.
Replace both batteries with new ones.
Make sure the remote control is not disabled
(for disable/enable the remote control, please
refer to the section of Remote Control).