Choosing A Place For The Product; Using The Product - Epson WorkForce Pro WP-M4525 User Manual

User's Guide
❏ If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are fuses in the plug,
make sure you replace them with fuses of the correct size and rating.

Choosing a place for the product

Observe the following when choosing a place for the product:
❏ Place the product on a flat, stable surface that extends beyond the base of the product in all directions. If you place
the product by the wall, leave more than 10 cm between the back of the product and the wall. The product will not
operate properly if it is tilted at an angle.
❏ When storing or transporting the product, avoid tilting it, placing it vertically, or turning it upside down;
otherwise ink may leak.
❏ Allow spaces behind the product for the cables, and space above the product so that you can fully raise the
document cover.
❏ Avoid places subject to rapid changes in temperature and humidity. Also, keep the product away from direct
sunlight, strong light, or heat sources.
❏ Do not place or store the product outdoors, near excessive dirt or dust, water, heat sources, or in locations subject
to shocks, vibrations, high temperature or humidity. Do not use with wet hands.
❏ Place the product near a wall outlet where the plug can be easily unplugged.

Using the product

Observe the following when using the product:
❏ Do not insert objects through the slots in the product.
❏ Take care not to spill liquid on the product.
❏ Do not put your hand inside the product or touch the ink cartridges during printing.
❏ Do not touch the white flat cable inside the product.
❏ Do not use aerosol products that contain flammable gases inside or around the product. Doing so may cause
fire.
❏ Do not move the print head by hand; otherwise, you may damage the product.
❏ Always turn the product off using the P On button. Do not unplug the product or turn off the power at the outlet
until the LCD panel has turned off completely.
❏ Before transporting the product, make sure that the print head is in the home (far right) position and the ink
cartridges are in place.
❏ Leave the ink cartridges installed. Removing the cartridges can dry out the print head and may prevent the printer
from printing.
❏ Be careful not to trap your fingers when closing the scanner unit.
Safety Instructions
9