Carburetor Adjustment Emission - Echo HCA-2400 Operator's Manual

28
CARBURETOR ADJUSTMENT
Emission Models (with limiter caps)
Level 2.
Tools required: Screwdriver, Tachometer (ECHO P/N 99051130017).
Parts required: None.
NOTE
Every unit is run at the factory and the carburetor is set in compli-
ance with EPA Phase 1 and California Emission Regulations. In
addition, the carburetor is equipped with HI and LO needle
adjustment limiters that prevent settings outside acceptable limits.
1. Before adjusting the carburetor, clean or replace the air filter and
spark arrester screen.
2. Start engine and run for several minutes to reach operating
temperature.
3. Stop engine. Turn HI speed needle (A) CCW (counter clockwise)
to stop. Turn LO speed needle (B) midway between full CCW and
CW (clockwise) stops.
4. Idle Speed Adjustment.
• Start engine and turn "idle" speed adjustment screw (C) CW
until the blades begin to move, then turn the screw CCW until
blades stop moving. Turn screw CCW an additional 1/4 turn.
5. Accelerate to full throttle for 2-3 seconds to clear excess fuel from
engine then return to idle. Accelerate to full throttle to check for
smooth transition from idle to full throttle. If engine hesitates, turn
LO needle (B) CCW an additional 1/8 turn and repeat acceleration.
Continue adjusting until smooth acceleration results.
6. Check HI speed RPM at W.O.T. (Wide Open Throttle). HI speed
RPM should be set to specifications found on page 14 "Specifica-
tions" of this manual.
7. Check idle speed and reset if necessary. If a tachometer is avail-
able, idle speed should be set to the specification found on page
14 "Specifications" of this manual.
WARNING
When carburetor adjustment is completed, blades should not
move at idle, otherwise serious personal injury may result.
DANGER
SHC-1700, 2100 TYPE 1E
A
C
A
C
SHC-2400
HCA-2400
TYPE 1E TYPE 1E
C
SHC-1700, 2100 TYPE 1E
B
B