Operating Instructions - Haier HDY60M Owner & User Manual

OPERATING INSTRUCTIONS

Attention:
1. Before operation, clean off any dust and dirt inside the drum of the dryer
with a damp towel;
2. Clean off any debris on the lint filter and in the duct, to increase the drying
efficiency.
Turning on power
Before turning on the power of the dryer, check:
- Whether the supply voltage is in accordance with the value indicated
on the nameplate;
- The dryer must be securely grounded.
Preparation of the laundry load
- The dryer can only dry laundries which have been spun dry. Do not
put in laundry which is still dripping wet or still have excess water.
- Make sure all pockets are empty before placing them in the dryer
- Pull up zippers, sew and mend up loosened fasteners and tie up
dispersed ribbons to prevent the laundry from being entangled. If
necessary, put small items in a laundry bag.
- To achieve a better drying result, loosen up heavy loads before
loading it into the dryer.
Load to dry
Laundry type Cotton fabric
Maximum load 6kg
Warning:
1. Avoid drying wool, silk
and other delicate fabrics,
as it may damage it.
2. Do not exceed the
laundry load as
suggested. This could
damage the dryer as well
as the laundry load.
Synthetic fabric
3kg
Reference weight of fabrics for drying
Jeans
Overalls
(cotton appr 950g)
Pajamas
Blended fabric
(appr 200g)
clothes
Shirts
(appr 800g)
(appr 300g)
T-shirt
Underwear
(appr 300g)
( appr 70g)
Socks
(blended fabrics
Jackets (cotton appr 50g)
appr 800g) Single bed sheets
Woolen blankets
(cotton appr 800g)
(appr 3000g)
4
OPERATING INSTRUCTIONS
1. Power up
Insert the power plug into an appropriate power outlet that is properly installed
and grounded. Operating power supply: 220-240V~/50Hz
2. Laundry loading
Open the door and load the laundry into the drum of the dryer. For a more
energy efficient and better drying result, make sure the load has been spun
dry. Try to loosen the load when placing in the dryer.
Note: Check labels on clothing before placing them in the dryer. Some articles
are not suitable for machine dry. High temperature may damage the fabric.
3.
Setting drying time
rn t
Tu he timer knob to set an optimal drying time according to the laundry.You
can choose cool wind cycle or warm cycle according to your needs.
Note:Before you set the drying time,ensure your hands are dry.
4. Program completion
Warm wind cycle:
Before the drying time comes to end, the dryer will interject cold air
to cool off the clothes.
After the timer stops,the arrowhead of the timer knob will point to OFF.
Open the door to remove the laundry
Cool wind cycle:
Throughout the cycle,the heater does not activate.The laundary is dried by cool wind.
Note:1.To avoid timer interruption,please do not turn the timer knob to the
gray area of the program cycle.
2.Clothes should go through a cooling down/airing phase of the cycle.
If for any reason the dryer is stopped before the cycle has finished,dry clothes
should be removed immediately and not left in the dryer.Clothes should be
spread out to cool and not left bunched eg.in a clothes basket.
Before you open the door, please switch off the power supply.
5.
Cleaning the dryer
Please clean the filter after use every time.
5
.