Brother HL1060 - B/W Laser Printer Service Manual page 78

Service manual
Table of Contents

Advertisement

I-15
Black spots
Possible cause
Step
Drum unit
Fixing unit
SR PCB
Note:
Clean the drum unit as follows:
(1) Place the printing samples in front of the process unit, and find the exact
(2) Turn the drum gear by finger while looking at the surface of the OPC drum.
Check
1
Are the spots at 94mm
intervals?
The problem is not solved after
printing a few pages.
2
Are the spots at 63mm
intervals?
And the problem is not solved
after printing a few pages.
3
Is the problem solved after the
SR PCB replaced?
portion of image defect.
Position of smudge on
the drum
CHAPTER IV -14
Result
Yes
Yes
Yes
94mm interval
Fig. 4.2
Fig. 4.3
Remedy
If toner remains stuck, wipe it
off gently with a cotton swab.
Replace the drum unit if the
OPC drum is scratched or
deteriorated (exposed).
(Refer to the following note.)
Check and clean the heat roller
with a cloth dampened with
alcohol.
Replace the fixing unit.
Replace the SR PCB.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hl-1060

Table of Contents