Power and
Fault LEDs
Test LED
Figure 2-4. Checking the LEDs on the 2910al-PoE+ switches
LED Behavior:
During the self test:
•
Initially, all the status, LED Mode and port LEDs are on for most of
the duration of the test.
•
Most of the LEDs go off and then may come on again during phases
of the self test. For the duration of the self test, the Test LED stays on.
When the self test completes successfully:
•
The Power and Fan Status LEDs remain on.
The Fault and Test LEDs go off.
•
•
The port LEDs on the front of the switch go into their normal opera-
tional mode:
–
If the ports are connected to active network devices, the LEDs
behave according to the LED Mode selected. In the default view
mode (Link), the LEDs should be on.
–
If the ports are not connected to active network devices, the LEDs
will stay off.
If the LED display is different than what is described above, especially if
the Fault and Test LEDs stay on for more than 60 seconds or they start
flashing, the self test has not completed correctly. Refer to chapter 4,
"Troubleshooting" for diagnostic help.
Installation Procedures
Switch port LEDs
Installing the Switch
2-7