Installing The Switch; Included Parts - HP J9146A - ProCurve Switch 2910al-24G-PoE Installation And Getting Started Manual

Installation guide
Table of Contents

Advertisement

Installing the Switch

The HP ProCurve 2910al Switches come with an accessory kit that includes
the brackets for mounting the switch in a standard 19-inch telco rack, in an
equipment cabinet, and with rubber feet that can be attached so the switch
can be securely located on a horizontal surface. The brackets are designed to
allow mounting the switch in a variety of locations and orientations. For other
mounting options contact your local ProCurve authorized network reseller or
ProCurve representative. This chapter shows how to install the switch.
C a u t i o n
If the switch is to be shipped in a rack, be sure to use only an HP 10K rack.
Mount the switch using rail kit, ProCurve 1U RK MT SWITCH 10K ALL, part
number 356578-B21 and shelf kit AB469A, HP rx 16/26 Factory Rackmount
Shelf Kit. Both kits must be used. Otherwise you will void the warranty.

Included Parts

The 2910al Switches have the following components shipped with them:
HP ProCurve Switch Quick Setup guide
HP ProCurve Switches General Safety and Regulatory Information
booklet
2910al Switch Specific Safety and Regulatory Information sheet
Read Me First
Customer Support/Warranty booklet
Console cable (5188-3836)
2
2-1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 2910al

Table of Contents