A Regulatory Compliance And Safety; Regulatory Compliance; Federal Communications Commission Notice For Class A Equipment; Cables - HP AK241A - StorageWorks 8Gb Simple SAN Connection Installation And Reference Manual

A Regulatory compliance and safety

Regulatory compliance

Federal Communications Commission notice for Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy, and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area may cause unacceptable interference, in which case the user will be required to
correct the interference at their own expense.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in
order to maintain compliance with FCC Rules and Regulations.

Laser device

All HP systems equipped with a laser device comply with safety standards, including International
Electrotechnical Commission (IEC) 825. With specific regard to the laser, the equipment complies with
laser product performance standards set by government agencies as a Class 1 laser product. The product
does not emit hazardous light.
WARNING!
To reduce the risk of exposure to hazardous radiation:
• Do not try to open the laser device enclosure. There are no user-serviceable components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device other than those
specified herein.
• Allow only HP authorized service technicians to repair the laser device.

Laser safety warning

This product uses Class 1 laser optical transceivers to communicate over the fiber optic conductors. The
U.S. Department of Health and Human Services (DHHS) does not consider Class 1 lasers to be hazardous.
The International Electrotechnical Commission (IEC) 825 Laser Safety Standard requires labeling in English,
German, Finnish, and French stating that the product uses Class 1 lasers. Because it is impractical to label
the transceivers, the following label is provided in this manual.
8/20q Fibre Channel Switch Installation and Reference Guide 57