Zoning The Iscsi Initiator And Fibre Channel Storage Wwpns; Creating Zones; Discovery Dynamic Check Box; Node Address Persistent And Node Address System Assigned Check Boxes - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Figure 29 Discovery Dynamic check box
3.
Select the Node Address Persistent check box
4.
Select the Node Address System Assigned check box
Figure 30 Node Address Persistent and Node Address System Assigned check
boxes
5. Click Apply.
6. Close the IP iSCSI window.
7. Select Admin > Save Configuration from the Device Manager menu bar.
8.
Configure transparent-mode static mapping on both iSCSI-enabled C-Series switches.

Zoning the iSCSI Initiator and Fibre Channel storage WWPNs

The unique WWPN of the iSCSI Initiator acts as a virtual Fibre Channel host available on the Fibre
Channel SAN. The WWPN is zoned with Fibre Channel storage as if it were a Fibre Channel HBA.

Creating zones

Use either the Fabric Manager or the switch CLI to create and modify SAN zones. HP recommends
creating separate iSCSI zones that contain the iSCSI WWPNs and the storage WWPNs that they access.
See the Cisco configuration documentation for information on creating, modifying, or activating SAN
zones. Figure 31
36
shows an iSCSI Initiator zoned with an Enterprise Virtual Array storage port.
(Figure 30).
(Figure 30).