Microsoft Iscsi Initiator Icon; Iscsi Initiator Properties Window; Add Target Portal Window - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

During setup, the install procedure places a Microsoft iSCSI Initiator icon
desktop as well as in the control panel. The Microsoft iSCSI Initiator also has a CLI. Refer to the user
guide for more information.
Figure 3 Microsoft iSCSI Initiator icon
To install the Microsoft iSCSI Initiator:
1.
Double-click the Microsoft iSCSI Initiator icon to open the iSCSI Initiator Properties window
(Figure 4).
Figure 4 iSCSI Initiator Properties window
2.
Click Add to add the IP Storage Services Modules (IPS-4, IPS-8), Multi-protocol Services Module
(14/2),, or MDS 9216i switch iSCSI Ethernet address to the initiator.
The Add Target Portal window appears
NOTE:
This example uses the GbE address (33.33.33.170).
Figure 5 Add Target Portal window
3. Enter the appropriate information in the following boxes:
• IP address or DNS name
(Figure 5).
(Figure 3) on the server
C-Series iSCSI 17