Accessing The Switch; Logging On And Configuring The Switch - HP 445860-B21 - 10Gb Ethernet BL-c Switch User Manual

Install the switch.
3.
A successful installation is indicated by a green Health LED. If the Health LED is amber or power is not
applied to the switch, see the "Troubleshooting" section of the HP BladeSystem enclosure setup and
installation guide for more information.
For a cabling diagram, see the HP BladeSystem enclosure setup and installation guide.

Accessing the switch

The switch is accessed remotely using the Ethernet ports or locally using the DB-9 management serial port.
To access the switch remotely:
Assign an IP address. By default, the switch is set up to obtain its IP address from a BOOTP server
1.
existing on the attached network.
From the BOOTP server, use the switch MAC address to obtain the switch IP address.
2.
From a computer connected to the same network, use the IP address to access the switch using a
3.
Web browser or telnet application, which enables access to the switch BBI or CLI. The switch logon
prompt appears.
NOTE:
switch locally and configure the IP address manually. After assigning the IP address to the
switch, then access the switch remotely.
To access the switch locally:
Connect the switch DB-9 serial connector, using a null-modem serial cable to a local client device
1.
(such as a laptop computer) with VT100 terminal emulation software.
Open a VT100 terminal emulation session with these settings: 9600 baud rate, eight data bits, no
2.
parity, one stop bit, and no flow control.

Logging on and configuring the switch

To log on to the switch:
If the switch does not obtain the IP address by means of the BOOTP service, access the
Installing the switch 20