Cisco 4116 - EtherFast Switch Design Manual page 46

All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Uploading a New Firmware Image
If the keyboard is not running release 1.7x, follow these steps to upgrade the firmware:
Step 1. Download and install the IntuiKey downloader program.
Step 2. Download the firmware image from the Bosch website. The filename should be similar to
IntuiKey_firmware_1.73.s20.
Step 3. Connect the serial cable to the PC and the keyboard.
Step 4. Place the keyboard in Bootloader mode. To do so, while powering up the keyboard, press
and hold the 1 and 0 buttons simultaneously.
Step 5. Launch the IntuiKey Firmware Upgrade Utility (filename: IntuiFUU.exe) as shown in
Figure 51.
Figure 51. Firmware Upgrade Utility
Step 6. Specify the location of the firmware file and the proper Windows COM port and click
Download. The download process begins as shown in Figure 52.
Figure 52. Firmware Upgrade Utility
Step 7. Press the [Clr] button on the keyboard when finished. The keyboard should boot up with
the new firmware image.
Uploading a New Language File
Cisco provides an updated language file that enhances the keyboard functionality and
communication with the ISP. To upload language file to the keyboard, follow these steps:
Step 1. Download and install the IntuiKey configuration software.
Step 2. Download the language file from the Software Download page at http://www.cisco.com.
The filename should be similar to: IntuiKey_ciscoIPS_v2.int. This version should be
compatible with the proper keyboard firmware image.
Step 3. Connect the serial cable to the PC and the keyboard.
Step 4. Place keyboard in Bootloader mode. To do so, while powering up the keyboard, press
and hold the 1 and 0 buttons simultaneously.
Design Guide
6-6
Page-6-6