Operating The Dishwasher - Bosch SHV7ER53UC Operating Instructions Manual

Operating the Dishwasher

Start the dishwasher
Open the door and press the [On/Off] button. The LED of the last selected cycle flashes.
1
Select a cycle and desired options.
2
Press [Start] and close the door to begin the cycle.
3
Cancel a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
2
Close the door and wait about 1 minute while the dishwasher drains.
3
Open the door and press the [On/Off] button.
4
Interrupt a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press the [On/Off] button to turn the unit off.
2
To resume the cycle, press the On/Off button and close the dishwasher door.
3
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "r:05".
4
Press the "C" button to select the desired setting.
5
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Press [Start] to save the setting and close the door.
6
InfoLight
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "1:01".
4
Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.
5
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
Open the door and press the [On/Off] button.
1
Press the [+] button until the display jumps to "h:01".
2
Press the [+] or [-] button until the displayed time corresponds with your requirements.
3
h:01 = 1 hour delay
h:24 = 24 hour delay
Press [Start] to activate delay start.
4
To cancel delay start:
Press the [+] or [-] button until "h:00" is indicated on the digital display.
1
Press [Start] to save setting and close the door.
2
13