Pioneer 1014TX-K - THX Select A/V Receiver Service Manual page 149

5
+/–
Use to adjust the effect and channel levels, as well
as to change Dolby Pro Logic IIx and Neo:6 Music
parameter settings.
SLEEP (SHIFT & –)
Use to put the receiver in sleep mode and select the
amount of time before the receiver turns off
DIALOG E (SHIFT & +)
Use to make dialog stand out when watching TV or
a movie.
10 SHIFT
Press to access the DVR controls (above the component
control buttons) as well as some RECEIVER controls.
11 SOURCE
Press to turn on/off other components connected to the
receiver.
12 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you're setting
the remote to control other components.
SETUP
Indicates the setup mode, from which you choose the
options below.
PRESET
LEARN
DIRECT F
ERASE
RESET
READ ID
13 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(INPUT ATT, etc). Also use this button to set up surround
sound.
14 VOL +/–
Use to set the listening volume.
5
6
15 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
Operating range of remote control unit
The remote control may not work properly if:
• There are obstacles between the remote control and
the receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
VSX-52TX
6
7
30
30
7m
7
8
A
B
C
D
E
F
149
8