Temperature Regulation - Kenmore 33094 - Power Miser 9 Owner's Manual

Temperature Regulation
Due to the nature of the typical gas water heater, the water
temperature in certain situations may vary up to 30F ° (16.7 C°)
higher or lower at the point of use such as, bathtubs, showers,
sink, etc.
Water temperature over 125°F
(52°C) can cause severe burns
instantJy resulting in severe injury
or death.
Children, the elderly, and the
physically or mentally disabled
are at highest risk for scald injury.
Feel water before bathing or
showering.
Temperature limiting valves are
available
Read instruction manual for safe
temperature setting
Ho'n'ER WATER CAN SCALD: Water heaters are intended to
produce hot water. V_ter heated to a temperature which will
satisfy space heating, clothes washing, dish washing, and other
sanitizing needs can scald and permanently injure you upon
contact. Some people are more likely to be permanently injured
by hot water than others. These include the elderly, children,
the infirm, or physicelly/mentally handicapped. If anyone using
hot water in your home fits into one of these groups or if there is
a local cede or state law requiring a certain temperature water
at the hot water tap, then you must take special precautions. In
addition to using the lowest possible temperature setting that
satisfies your hot water needs, a means such as a mixing valve
should be used at the hot water taps used by these people or
at the water heater. Mixing valves are available at plumbing
supply or hardware stores. Follow manufacturer's instructions
for installation of the valves. Before changing the factory setting
on the thermostat See Figures 21 and 22.
Never allow small childrento use a hot water tap, or to draw their
own bath water. Never leave a child or handicapped person
unattended in a bathtub or shower.
NOTE: A water temperature range of 120°F-140°F (49°C-60°C)
is recommended by most dishwasher manufacturers.
The thermostat of this water heater has been factory set at its
lowest position. It is adjustable and must be reset to the desired
temperature setting for energy efficient operation at the minimum
water temperature setting that meets your hot water needs. To
reduce the risk of scald injury, 120°F (49°C) is preferred starting
point. Some states have a requirement for a lower setting.
Align the index bar on the thermostat with the desired water
temperature as shown in Figure 21.
Turn the water temperature dial clockwise ( f'_ ) to increase
the temperature, or counterclockwise ( _ ) to decrease the
temperature.
Should overheating occur or the gas supply fail to shut off, turn
off the manual gas control valve to the appliance.
Robertshaw Gas Valve
Gas Control
Knob
130"F
Reset _ Dial Stop Bar
Sutton 140°F
r _ _/ Bar
Index _ r_ 150OF
Ba,_ <i'_ I
Bar"h O
160,F _'_
aar
-- _ _Ternperature Dia
120°F
FIGURE 2t.
160°F (71°C) About 1/2 second
150°F (66°C) About %1i2 seconds
140°F (60°C) Less than 5 seconds
130°F (54°C) About 30 seconds
120°F (49°C) More than 5 minutes
80°F (Z7°C)
FIGURE 22.
19