Removing The Monitor Base - HP L1940 - 19" LCD Monitor User Manual

Setting Up the Monitor

Removing the Monitor Base

The monitor base can be removed to mount the monitor on a wall,
a swing arm or other mounting fixture. Read the caution and
warning statements below before beginning the procedure.
Ä
CAUTION: Before beginning to disassemble the monitor, be sure the
monitor is turned off and the power and signal cables are both
disconnected.
Lay the front bezel down on a soft area to prevent it from getting
scratched, defaced, or broken
Å
WARNING: Do not remove the base from the monitor while the
monitor is in the upright position. Before removing the monitor from
the base, ensure that the monitor is lying flat, front bezel down, and
that the base is set to the maximum base extension. Attempting to
remove the monitor from the base while upright in the minimum base
extension may result in injury to the user.
1. Disconnect and remove the signal and power cables from the
back of the monitor.
Ä
CAUTION: Ensure that the bottom of the monitor base is positioned
over a table or desktop before removing the base from the monitor.
3–10 User Guide